How does Juzt-Reboot™ Netclone work:
Netclone gives you the ability to clone upto 200 systems on a local area network without the use of a server. Juzt-Reboot™ JR-PCI-NT can communicate with your network device and provide full functionality using the network device packet driver. Our Netclone technology transmits data by multi-cast, transmitting too all systems at the same time. It will generally take a few minutes too hours depending on the physical data capacity. This feature allows you to maintain alot of machines whilst only physically maintaining one system (master system).

At what speed does Juzt-Reboot™ PCI-NT Netclone transmit data:
Generally Juzt-Reboot™ PCI-NT will transmit data at 100mb per minute, it is recommended that your network speed is at least 100mbps. Though if your network speed is faster, this will increase the data transmission rate of PCI-NT Netclone operation.

What Juzt-Reboot™ card drivers should I be using:
In order to use the latest Juzt-Reboot™ features for Netclone Operation & Windows Remote Console Control Applications, you will need to be runnng driver version 8.16 [download driver V8.16]

Why is it necessary too update Juzt-Reboot™ with LAN Packet Driver:
LAN Packet Driver Update - upgrades Juzt-Reboot™ with the packet drivers of the most commonly used network ethernet adaptors. This update can be installed by placing the LAN Packet Driver floppy in drive A: and selecting [Upgrade] from the Juzt Reboot™ options menu . This update will allow you to run Netclone Operation automatically. [Net-Clone] > [Net-Clone setup] - Then select your network card brand or chipset from the list and press [esc] too save & exit.

What network adaptors does LAN Packet Driver Update 2.2P support:
LAN Packet Driver 2.2P currently supports the following network cards-

back to top /\

My network adaptor is not supported by LAN 2.2P update:
Don`t worry the Netclone operation can be run manually, you will however need to run your network card packet driver from real DOS mode, on both the sending & receiving machines. This driver can be found on the driver disk which accompanies your network card. Contact [support] and request LAN 2.2P tools & instructions.

Why is it necessary to enter an IP address in the Netclone setup:
The IP addressing information entered in the Netclone setup, is for internal Juzt-Reboot™ Netclone operation only. This allows you to identify other systems on your local area network when cloning from the master system. If you wish, you can [Auto Allocate] this information to the receiving machines from the master. - You can also [Auto Allocate] - [Group Names] & [Computer Names] from the master system too the receiving machines.

What is the point of assigning a [Group Name] to a PC:
Assigning a [Group Name] to a PC allows the administrator to pick out individual groups of PC`s to clone information too, from the master system. For example, if you had a number of classrooms in a building and you only wanted to clone information to one particular classroom, you would assign a different [Group Name] to each classroom. Otherwise if no [Group Names] are assigned the master system will pick up all PC`s on your LAN and ready them for Netclone.

I want to change my passwords or other card configuration options:
You can change the Juzt-Reboot™ passwords or other configuration options on all machines on your LAN in about 15 seconds, all you need to do is change them on the master system and then select [Parameter Data Only] in the Netclone [Sending Menu]. This will send out new card parameter information to all receiving machines logged onto the master system, without affecting the actual operating system data.

back to top /\