================================================================================
    Juzt-Reboot™ - Optimum Configuration Options for Home/ SOHO Users 
================================================================================

     Note: Before you configure your Juzt-Reboot card, please ensure you have 
           installed the [Setup.exe] on the driver floppy in Windows under 
           [Supervisor Mode] 

1.   At the Juzt-Reboot multi boot menu - 

     Press [F10] and enter [Supervisor Password]

     Note: Default passwords are the [Enter] key until set by user.

     You will now see the card configuration menu 

2.   Select [Disk Setup] 

     You will notice the [No.Attrib 1] highlighted, press the right arrow key to 
     move across to the [Name] and enter name of your choice for the partition.

     Now press the [Tab Key] to move across to the right hand side menu.

     Leave the [File System] set as is, because this is automatically picked up 
     by the card at installation. Move down to the [Restore Type] using the
     down arrow and then use the Page Up/ Down keys to set the restoration 
     to [Manual]

     Note: Default value is [Every Reboot]

     You may set a [Boot Password] for additional security, but this is not 
     that necessary for your environment.

     Press [Esc Key] and move the red highlight bar over [Save] and press [Enter]        

3.   Select [CMOS Tool] and move red highlight bar over [OK], 

     The following message will be seen-

     "Analzying CMOS data...., Please Restart machine"

     Power your machine ON and OFF do not use [CTRL+ALT+DEL], your machine will
     now reboot 2-3 times whilst the data is analyzed. When this stops will be
     back at the Juzt-Reboot multi boot screen, repeat [Step 1].

     Once you have entered back into the configuration menu, select [Options]
     and move the highlight bar over [Auto Restore CMOS], select [Enable]
     using the page up/ down keys.  
      
     Press [Esc Key] and move the red highlight bar over [Save] and press [Enter]

     Your CMOS/ BIOS setup is now fully protected.
    
     Note: If you wish to add a hardware device to your machine, you will need
           to disable the [Auto Restore CMOS] setting in [Options], and repeat
           [Step 3] again, once you have installed the hardware device.

4.   Now enter back into [Options] to complete configuration-

     [Boot Sequence] - Set to C Only - Stops any booting from external drives 
                       on system startup.

     [Safety Value] - Set to advanced - stops any low-level format utilities in 
                      your Windows Operating System.

5.   Set passwords if you feel necessary-

     [Supervisor] - Required to access the card setup configuration menu.
     [Restore] - Required if you wish to restore your last saved hard drive state.
     [Backup] - Required if you wish to backup new additional information. 

     Note: if you leave these passwords blank, the default password will be
           the [Enter Key] for each.

     Finally     
 
     Press [Esc Key] and move the red highlight bar over [Save] and press [Enter]

     Select [Exit] and press [Enter Key]

     Your machine will now reboot and is fully protected.

================================================================================
If you have any questions or problems please contact support@juzt-innovations.ie 
================================================================================