================================================================================
   Juzt-Reboot™ - Optimum Setup for Corporate & Government 
================================================================================

1. SETUP OPTIONS - JR-PCI-NT
=============================================

     When you see the buffer screen on installation - default [502MB], it is 
     recommended increasing to [1004MB] using pg up/dw keys. 
     - (Express Installation)

     After the Juzt-Reboot Card has installed allow your PC to boot to your 
     Windows Operating System. Then install the setup.exe found on the Card
     software driver disk:

     Run - A:\Setup.exe

     Your system will now shutdown & reboot

     Allow boot back into Windows (to make sure everything has fully installed)

     Now shutdown & restart system
 
                        - at the Juzt-Reboot multi-boot menu press [F10]
                          to enter into card setup options

                        - default password is [Enter] key

1.  Select [CMOS TOOL] then select [OK] - your PC will now reboot twice &
    analyze your CMOS data. Once this has completed, enter back into the
    card setup options by pressing [F10] at the boot menu.

2.  Select [OPTIONS] 
    
    - Set 

    [Boot Sequence]         - C Only
    [Auto Restore CMOS...]  - Enable
    [Safety Value]          - Advanced

    - Set Passwords

    [Supervisor Password]   - password for card setup options
    [Restore Password]      - password entered before restoring saved image
    [Backup Password]       - password entered before backingup new image

3.  Select [ESC] to save

4.  Select from setup menu [DISK SETUP]

    - Set C: drive

    [Restore Interval]      - Manual/ Every Reboot/ Everyday
                                     2nd/ 3rd option assumes user data is 
                                     being saved on the server or D: drive.

    - Set D: drive (optional)

    [Clear Interval]      - Disable/ Every Reboot/ Weekly/ Monthly
                            Note: user could save data to D: drive and backup 
                            software on server could collect from that path, if
                            C: drive restore interval was set [Every Reboot]

5.  Select [ESC] to save & exit

6.  In your Operating system change the path of your email application to 
    D: drive. So if C: drive restore interval is set [Every Reboot], data will
    remain on D: drive.

================================================================================
If you have any questions or problems please contact support@juzt-innovations.ie 
================================================================================